With the continuous improvement of the performance of the current trademark die-cutting machine, the plastic bottle cap capper has been widely used in the industry, resulting in the increase of production. Because the die-cutting process is a commonly used process for packaging and printing products, it is to use the die-cutting cutter to combine the die-cutting plate according to the design requirements of the product, and under the effect of pressure, the printed products or other ring billets are rolled and cut Forming process of required shape or cut.

Plastic cap Capping Machine and die-cutting machine is to use steel knife, metal mold, steel wire, through the pressure plate to exert a certain amount of pressure, the printed matter or cardboard is rolled into a certain shape. If the whole print is pressed into a single graphic product, it is called die-cutting; if the steel wire is used to press out the mark or leave a bent groove mark on the print, it is called indentation; if the two templates of yin and yang are used, by heating the mold to a certain temperature, the pattern or font with three-dimensional effect on the surface of the print is called bronzing; if one substrate is used to copy on another substrate, it is called pasting Therefore, it is necessary to select the appropriate equipment according to the actual situation, so as to ensure that there is no fault in the production.

When the trademark die-cutting machine is running, it needs to follow a series of operation specifications. Before running, it needs to fill in the first inspection record. Before half an hour of running, it needs to carry out continuous spot check on the products. During the process of spot check, it needs to find out the problems, solve the root causes of the problems, and fill in the record of re check. During normal operation, it needs to use the time of loading to further spot check the products, and the bending and warping are flat Board, adjust the speed of the equipment to the speed suitable for paper placement, to prevent the occurrence of safety hazards.

For the semi-finished products with printing displacement, the plastic cap capper shall be carefully selected and inspected, and the displacement shall be classified to reduce the loss. According to the production quantity of the work order, the number of products to be produced shall be set, which shall not be over manufactured. When the garbage can of auxiliary workers is full, the machine shall be shut down to prevent potential safety hazards. Ensure that the paperboard is consistent with the work order, the die-cutting size is consistent with the die-cutting drawing size, the position of the die-cutting printing surface is consistent with the position of the printing manuscript, whether the pressing line is in the middle, the depth is appropriate, easy to fold, the paperboard does not burst, no broken line, no extra indentation line, whether the knife edge is smooth and clean, and no burr, so that the product can meet the requirements of the industry.